• Includes NIST-Traceable Calibration Certificate
• The time-based B-Scan feature displays a cross section of the test material. It is commonly used to display the profile of the bottom surface of the test material.
• Built in hardware AGC gain control for through paint measurements in multi mode operation.
• The TI-MMX-SDL has the ability to store 64 custom user defined setups. All factory setups can be selected, edited and saved to any setup location.
• Use the visual alarm to set hi and lo limits for applications requiring specific tolerances. If the actual thickness value is above or below the limits, a red light is illuminated.
• The TI-MMX-SDL also comes complete with our Windows® PC software for transferring data to and from a PC.
• The high speed scan feature speeds up the inspection process by making 32 measurements per second. Remove transducer from the test material, and display the minimum measurement scanned.
• Use the AUTOFIND feature to locate the detection point, while automatically adjusting the display to bring the signal into view.
• IP 65 Rated
• CE Certified
• Warranty: Gauge: 2 Years Probes: 90 Days
• Made in USA

• Range in Steel:
• Pulse-Echo Mode: Pit and Flaw detection measures from 0.63 to 254 millimeters (0.025 - 9.999inches)
• Echo-Echo Mode: Thru Paint & coatings measures from 2.54 to 102 mm (0.100 - 4.000 inches). Range will vary depending on the thickness of the coating.
• Resolution: .001 inches (0.01mm)
• Velocity Range: .0492 to .3936 in./ms (1250 to 9999 meters/sec)
• Units: English & Metric
• Measurement Modes: Pulse-Echo (flaws, pits); Echo-Echo (thru-paint)
• Transducer Types: Dual Element (1 to 10 MHz).
• Memory: 16 megabit non-volatile ram
• Memory capacity: 12,000 pages with 1 reading and waveform per page
• Power Source: Three 1.5V alkaline or 1.2V NiCad AA cells
• Battery Life: Typically operates for 150 hours on alkaline and 100 hours on NiCad
• Auto Power off: if idle 5 min
• Display: 1/8 in. VGA grayscale display 62 x 45.7mm
• Keyboard: Membrane switch with twelve tactile keys
• Case: Extruded aluminum body with nickel-plated aluminum end caps (gasket sealed).
• Operating Temperature: -14° to 140°F (-10° to 60°C)
• Weight, ne:  383 grams
• Dimensions: 63.5 W x 165 H x 31.5 D mm
• Warranty: 2 year limited
• Certification: CE Approved, Factory calibration traceable to national standards

• (1) Checkline TI-MMX-SDL High Performance Ultrasonic Thickness Gauge
• (1) T-102-2700 probe
• (1) 4 oz. bottle of coupling fluid
• (2) AA batteries
• (1) NIST-Traceable Calibration Certificate
• (1) Data Transfer Software
• (1) Carrying case
• (1) Instruction Manual

Brochure/Datasheet

Instruction Manual

Download

Note: Prices are not binding at any time subject to change without prior notice