PIE PIECAL 434 [PIE 434] Automated 4-20mA Loop Calibrator with Loop Diagnostics

The Practical Instrument Electronics (PIE) 434 automated diagnostic 4-20 mA calibrator allows you to check, calibrate and measure all of your current signal instruments in a 4-20 mA DC loop. It can be used at any access point in your loop. You can calibrate recorders, digital indicators, stroke valves or any instruments that get their input from a 4-20 mA loop.

Quickly diagnose ground fault and current leakage with the PIE 434 automated diagnostic 4-20 mA calibrator's loop diagnostic technology. PIE 434 calibrators also feature automatic output stepping and ramping. Press and hold the dial to automatically step from 4-20 in two, three or five steps or choose a continuous ramp.

With the PIE 434 calibrator, you can check loop wiring and receivers, as well as check controller outputs or measure the milliamp signal in the loop. The Practical Instrument Electronics 434 automated diagnostic 4-20 mA calibrator includes a rubber boot, tilt stand, backlit display with large digits, rugged switches and a battery compartment for fast battery changes.

---

Features:

---

• Calibrate Milliamp Instruments
  • Source 0.00 to 24.00 mA & -25.0 to 125.0% of 4-20 mA
  • Read 0.00 to 52.00 mA, -99.99 to 99.99 V
  • Simulate 2-Wire Transmitters, Power & Read 2-Wire Transmitters
• Menu Selectable 250 W resistor for HART compatibility
• Calibrate with confidence
• Accurate to ±0.025% of Span at 4.000 & 20.000 EZ-CHECK outputs
• Easy-to-Read Display
• Turn on the backlight to read in dark areas of the plant
• Locate Loop Current Leakages
• Automatic indication of Loop Current and Leakage Current
• Measure ground current leakage from faulty wiring, flooded conduit and corrosion bridges
• Leakage appears as a Zero Shift and helps you decide if the transmitter needs calibration or if there is some problem in the loop wiring

• Faster Calibrations
• Instantly select three outputs with EZ-CHECK switch Easily find trip points with two speed EZ-DIAL plus Automatic Stepping & Ramping

• Functional Replacement for the Altek 434

---

What's In The Box:

---

• (1) Test Lead Set 0200207
• (1) NIST Calibration
• (1) Small Carrying Case 0200205

---

Brochure/Datasheet

---

Instruction manual

Note: Prices are not binding , subject to change without prior notice