• Monoblock receiver AP-019 with built-in GPS/GLONASS module (option)
• 20W AG-105 transmitter
• high precision location of underground utilities up to 10m
• direct digital measurement of cable current up to 10 amperes
• Location of non-conductive and non-metallic utilities with optional pushing rod and pipe sonde

• AP-019.1 Receiver:
• Receiver filter centre frequency: Switching 50(60) / 100(120) / 512 / 1024 / 8192 / 32768 Hz
• "Wide band" frequency band: 0,04...8 kHz
• Frequency range "Radio": 8...40 kHz
• Maximum amplification factor of the electric path: 120 dB
• Dynamic range of the input signal: 100 dB
• Number of embedded sensors: 4
• Max. sensitivity: 5 mkA at 1m distance (at 33 kHz)
• Selectivity: Q-3 dB>100, stopband supression up to 120 dB
• Sensors type: Inductive
• Sensitivity control: Auto - for 2D display "Route";  Semi-automatic or manual (optional) - for the "Graphics"; Automatic or manual (optional) - for the "2F" mode
• Determination the burial depth of the route: Automatically in "Route" mode 0...10 m
• Laying depth identification accuracy: ±5%
• Identification of the effective current in the route: Automatically in "Route" mode 0.001...49,99 A
• Accuracy of current measurement of received signal: ±5%
• Support of energy saving (intermittent) modes of the route locating transmitters: At combined work with the route locating transmitters made by "TECHNO-AC" ("Pulse" mode)
• Visual indication: Graphic display LCD display, 320x240 pix., with LED backlight
• Induced parameters: Parameters of setting and control;  2D visualization of the route location relative to the device; Graphics of the signal level from sensors; - Route burial depth - signal current
• Audio indication: Headphones: natural filtered sound; Built-in transmitter: synthesized sound FM, sound indication of buttons pressing
• Permissible impedance of the headphones: Min. 32 Ohm
• Power source: 4...7 V (4 type C batteries)
• Time of continuous operation from the single battery set: Not less than 20 hours
• Automatic shutdown when the device is not active: After 30 minutes of inactivity
• Operating /storage temperature range: -20...+60 / -30...+60°С
• Dust and water protection degree: IP54
• Dimensions: 330x140x700 mm
• Weight: 2,4 kg
• AG-105 transmitter:
• The frequencies of the continuous "Co" or pulse "Pu" signal, Hz ± 0,1% - "kHz"
  
• Load "clips" or "clamp" : 512 - "0.5" / 1024 - "1.0" / 8192 - "8.2" / 32768 - "33"
• "Antenna" modes: 8192 - "8.2" / 32768 - "33"
• Operating modes:
• "Antenna" modes: Internal transmitting inductor "In"
• "Modulation" modes (special form signal): Pulse "Pu" (short-term transmissions of the sine signals); Transmission duration 0,12 sec.; Transmissions repetition frequency 1 Hz. Dual-frequency "2F" (simultaneous frequency generation 1024 Hz, 8192 Hz); Amplitudes ratio 4/1 (respectively)
• Output parameters under power supply voltage: 12…15 V
• Output current, А
• Restricted by the program under manual increment, ≥: 5 - at frequency 512 Hz "0.5" / 1024 Hz "1.0" / 8192 Hz "8.2" / "2F". 3 - at frequency 32768 Hz "33"
• Set by the program for automatic adjustment with the external load of "clips" or "clamp", ≥: 0,2 - at frequency 512 Hz "0.5" / 1024 Hz "1.0" / "2F". 0,1 - at frequency 8192 Hz "8.2" / 32768 Hz "33"
• Maximum output voltage, V
• Depending on "modulation", ≥: 32 - in the dual-frequency modulation mode "2F". 40 - in other modes
• Maximum output power, W
• Restricted by the program, ≥: 20 - in the continuous "Co" and pulse "Pu" modes at frequencies 512 Hz "0.5" / 1024 Hz "1.0" / 8192 Hz "8.2" at load resistance up to 80 Ω; In dual-frequency mode "2F" at load resistance up to 50 Ω. 6 - at frequency 32768 Hz "33" at load resistance up to 260 Ω
• Power supply sources:
• Operating range of the supply voltages: Minimally acceptable voltage for oscillation start-up: 7 V "Bt", < 9 V "Ас"; Maximum allowed voltage for operation - 15 V; Automatic shutdown voltage in the "oscillation" mode: < 4.2 V "Bt", < 7.9 V "Ас" 
• Battery set: 8 "alkaline" cells 1.5 V "type С" (recommended – "Duracell ® ULTRA")
• External power supply sources (optional):  Battery "12 V" (e.g. automotive);  Output voltage 11…14 V, maximum current not less than 4 А; Mains power supply adapter АG114М.02.020 (extra accessory based on GS60A15-P1J "MEAN WELL"); Output voltage 15 V, power 60 W
• Operating time ("life cycle"): While in operation of the battery set "type Сх8" is defined by the quality (capacity and "load capability") of the applied alkaline cells and can be equal to from 4 to 6 hours in the "Co" и "2F" modes or from 20 to 30 hours in the "Pu" mode at initial output voltage 7 W in "continuous" modes "Co" / "2F" or at initial output voltage 15 W in pulse modulation mode "Pu".Under the external power supply is fully conditioned by this external energy source characteristics therefore under mains supply operating time is unlimited
• Operational characteristics:
• An automatic control over the output voltage during oscillation process: Proportional control over the output power depending on the "energy potential" of the power supply source
• Automatic shutdowns of the device: At power supply voltage in the "stop" mode < 6.5 V "Bt", < 8.8 V "Ас"; At power supply voltage in the "oscillation" mode < 4.2 V "Bt", < 7.9 V "Ас"; At power supply voltage > 15.5 V; - In case of exceeding of the admissible absorbed current value (the exact figure depends on the actual mode); - In case of short circuit of the output during the adjustment process (actuation of the hardware safety system of the terminal amplifier); - In case of non-compliance of the oscillation mode settings depending on whether the external antenna is installed in the output or not (the switch to the "stop" mode); - In case of "long" (≈ 100 sec.) downtime in the "stop" mode (if the buttons are not pushed)
• Adjustment with load: Automatic, up to the reaching of the specific consumption rate or attainment of the load current: ≥ 0,2 А at frequencies 512 Hz "0.5" / 1024 Hz "1.0" / "2F"; ≥ 0,1 А at frequencies 8192 Hz "8.2" and 32768 Hz "33". Manual (via buttons LESS / MORE « ») after the automatic adjustment
• Connection options to the communication under examination: "Contact" connection with "earth return"; "Non-contact" connection with application of the internal transmitting antenna "In";  "Non-contact" connection using the transmitting induction "clamp" (selection of the cable from the bunch us possible)
• Electromagnetic compatibility:
• Classification in accordance with the Russian State Standard (GOST) 51318.22-2006: Class A
• Structural parameters:
• Power output amplifier: The technology - updated CLASS D; Efficiency to 85%
• LED indicators: Separate light-emitting diodes indicating parameters and modes; Digital indicator displaying the modes and parameters values and also showing output parameters of the "MULTIMETER" measurements, e.g.: output voltage (V), load current (А), load power (W) and load resistance (Ω / kΩ)
• Overall dimensions of the electronic unit (case), not more than, mm: 216х180х105
• The weight of the electronic unit, not more than, kg: 2
• The admissible environment temperatures range when in operation: -30…+60°С, with "battery" power supply it is not recommended to use the device under sub-zero environmental temperatures
• Ingress protection rating: IP65 (when the enclosure-case is shut)

• (1) Receiver АP-019.1
• (1) Transmitter АG-105
• (2) Contact magnetic AG120.02.090
• (2) Grounding rod AG110.02.004
• (1) Operation manual

Brochure/Datasheet

Instruction Manual

Download

Note: Prices are not binding at any time subject to change without prior notice