• AP-019.3 receiver:
• Advanced digital monoblock receiver AP-019.3.
• Indication of utility on the screen.
• Automatic measurement of burial depth and current rate.
• Built-in GPS/GLONASS module to store the coordinates of located utility.
• "Probe" mode for locating NON-METALLIC utilities with pushing rod and pipe sonde (optional).
• Several indication modes: "Route", "Graph", "Graph+", "MIN&MAX", "R.dis." (Relative distance to the utility) and "2 frequencies" which allow operator to utilize full potential of device.
• Additional functions when connecting external sensors.
• Vast range of supported frequencies (50(60) / 100 (120) / 512 / 1024 / 8192 / 32768 Hz, WideBand 40…8000 Hz, Radio 8…40 kHz).
• Menu in English and Russian.
• Connect Power Bank and work at sub-zero temperatures, Power Bank is hidden under the clothes of the operator.
• MAG-05.X.XX transmitter set:
• Transmitter set MAG-05.X.XX allows for sections of the pipeline, where there is the possibility of access to the pipeline on both sides, to ensure the warranty removal of the transmitter in case it gets stuck or breaks away, to apply the method of tracing with an auxiliary rope.
• In this case, the following procedure is applied:
  
• On the pushing rod instead of the transmitter, install a plug.
  
• Using the pushing rod, push the plug to the end of the channel.
• Replace plug with transmitter with a battery and a cap.
• Hook the auxiliary rope to the cap with a carabiner.
• Trace the utility by moving (pulling) the sonde with the pushing rod.

• AP-019.3 receiver:
• Receiver Quasi resonant filter centre frequency: 50(60) / 100(120) / 512 / 1024 / 8192 / 32768 Hz
• “Wide band” frequency band: 0,04...8 kHz
• Frequency range "Radio": 8...40 kHz
• Sonde frequency: 512 Hz
• Dynamic range of incoming signal: 120 dB
• Number of embedded sensors: 4
• Max. sensitivity (in "Graph" mode: F0 = incoherent distortion +10 dB is 31…35 kHz): 5 mkA at 1m distance
• Data log capacity: 2300 "points"
• Connected external sensors: CI-105, HP-117, DODK-117, DKI-117 (made by "TECHNO-AC")
• Sensitivity control: Auto-for 2D display "Route"; Semi-automatic or manual (optional) - for the "Graphic", "Graphic+", MIN&MAX and "Sonde"; Automatic or manual (optional) - for the "2F" mode
• Determination the burial depth of the route: Automatically in "Route" mode 0...10 m; By pressing a button in "Sonde" mode
• Burial depth identification accuracy: ±5%
• Identification of the effective current in the route: Automatically in "Route" mode: 0.001...49.99 A
• Accuracy of current measurement of received signal: ±5%
• Support of energy saving (intermittent) modes of the route locating transmitters: At combined work with the route locating transmitters made by "TECHNO-AC" ("Pulse" mode)
• Visual indication: Graphic display LCD display, 320x240 pix., with LED backlight
• Induced parameters: 2D visualization of the route location relative to the device;  Graphics of the signal level from sensors; Route burial depth; Signal current; Signal strength; Settings and control parameters
• Audio indication: Built-in speaker: natural filtered sound; buttons sound indication
• Power source: - 4...7 V (4 type C batteries); External Power Bank – optional
• Time of continuous operation from the single battery set: Not less than 20 hours
• Automatic shutdown when the device is not active: After 30 minutes of inactivity
• Operating /storage temperature range: -20...60°С / -30...60°С
• Dust and water protection degree: IP54
• Dimensions: 330x140x700 mm
• Weight (excluding batteries): 2,4 kg
• MAG-05.Х.ХХ transmitter:
• Transmitter frequency: 512 Hz
• Diameter of pipe transmitter: 40 mm
• Weight of pipe transmitter: 318 g ± 20 g
• Pipe transmitter operation time: up to 5 hours
• Pushing rod of cable pulling system diameter: 6 mm
• Additional wire cable diameter: 2 mm

• (1) Receiver АP-019.3
• (1) Set of pipe transmitter MAG-05.Х.ХХ
• (1) Operation manual

Brochure/Datasheet

Instruction Manual

Download

Note: Prices are not binding at any time subject to change without prior notice