• Frequency range: 10MHz to 6GHz
• Unlimited continuous 245MHz true I/Q streaming up to 2xUSB 3.0
• Dual receiver real-time bandwidth of 245MHz (2x124MHz)
• Sweep 6GHz in less than 5mS (1THz/s)
• Speed: 500 GHz/s
• I/Os: 1 Rx & 1 Tx
• 80 MHz/optional 120 MHz/245 MHz I/Q
• DANL (internal pre-amp on) Typ. -170 dBm/Hz3
• Parallel measurement of several frequency bands
• Dual USB true I/Q streaming up to 784MBytes/s
• I/Q vector signal generator bandwidth of up to 120MHz (seamless streaming)
• POI 97 ns (FFT-based), 10ns (direct I/Q-based)
• Exceptional dynamic range through the use of a 16-bit ADC with 2GSPS (Giga Samples per Second)
• Sample rate: 500 MSPS (16 Bit Dual 256 MSPS I/Q-Data)
• FPGA: 930GMAC/s
• FFT rate: 960 million FFT points/s (120 million FFTs/s)
• Stackable accessories
• Light and compact
• Includes software RTSA-Suite PRO with daily updates
• Many ways to display and analyze any received or recorded data

• Frequency range: 10 MHz to 6 GHz (1 Hz to 26 GHz in development)
• Real-time bandwidth Rx: Up to 245 MHz I/Q – via 2 x USB
• Real-time bandwidth Tx: 120 MHz I/Q
• POI :  Up to 97 ns (FFT-based), 10ns (direct I/Q-based)
• Max. power Rx: +23 dBm
• Max. power Tx:  +20 dBm
• DANL (internal pre-amp on): Typ. -170 dBm/Hz
• Amplitude accuracy (typ.): Typ. +/- 0,5 dB (compensated by FIR filter)
• USB streaming connection: One or two USB 3.0 (USB 3.1 Gen1; USB 3.2 Gen1)
• USB bandwidth (2 x USB 3.0):  Up to 784 MBytes/s sustained throughput to PC
• Frequency reference accuracy: 0,5 ppm (5 ppb via OCXO option)
• RBW (resolution bandwidth): 62 mHz to 200 MHz
• Measurement units: Over 20 (e.g. dBm, dBμV, V/m, A/m, W/m², dBμV/m, W/cm²)
• Detector; Min, Max, AVG, Peak, QPeak
• Attenuator range:  50 dB / 70 dB (0,5 dB steps)
• Traces : Over 20 (e.g. ACT, AVG, MAX, MIN, QPEAK)
• Measurement modes: True IQ or Power/Frequency data
• Trigger: Cursor, Measurement, Density
• ADC: Dual 2GSPS 16 Bit
• DAC: 2GSPS 14-Bit
• GPS: GPS/QZSS, GLONASS, BeiDou and Galileo (concurrent reception)
• GPS synchronisation:  +/- 10ns timestamping in each data packet
• External Frequenc Reference Input:  typ. 10MHz, 3,5VRMS into 50 Ohm (SMB-connector)
• FPGA:  XC7A200T-2
• DSP processing:  930 GMACs
• SDRAM: 2 GB
• RF connectors; SMA (Rx,Tx), SMB (Trigger, Refclock, GPS, PPM). All 50 Ohms.
• Temperature range (operation): 0 °C to +50 °C (extended -40 to +75 °C)
• Dimensions:  210 x 115 x 30 mm
• Weight: 850 g
• Power: USB 3.2 Gen 1 Type-C PD 3.0
• Power consumption: Typical 15 W
• Country of origin: Germany
• Recommended calibration interval: 2 years

• (1) V6RSA500X Spectrum Analyzer
• (1) USB Cable
• (1) USB Stick with RTSA-Suite Software

Brochure/Datasheet

Instruction Manual

Download

Note: Prices are not binding at any time subject to change without prior notice