Shop by Brand
Clamp Meters
Datacom and Networking
Ground Tester
Hand Tools
HVAC Equipment and Instruments
Life Sciences Equipment
Megohmmeter
Multimeters
Oscilloscopse
Power Measurement
Power Supplies
Power Tools
Process / Calibration
Safety Testing / Surge Testing
Safety Equipment
Signal Generators / Counters
Soldering Equipment
Spectrum Analyzers
Surveying Equipment
Thermal Imagers
Merk
Katalog
Test Equipment
Inspector Tools
Environmental
Power Tools
Your shopping cart is empty!
The PCE-DD-D is a Shore D durometer or hardness tester used to measure the Shore hardness of materials such as hard rubber, hard resin, acrylic, glass, thermoplastic and more. This Shore D hardness tester uses an impact rod with a 30º conical point and 50 Newtons (N) of force to make a surface indentation on material samples with a minimum thickness of 6 mm or 0.24 in. (Note: If a material sample does not meet the minimum thickness required, the sample should be reinforced on the back with more of the same material.)
By completing profiles, we can ensure you get the best service
